Skip to content

25 good parts: why a 12-part plate still needs three runs

A fully disclosed packing example connects edge clearance, plate count, handling and failure assumptions without pretending to be a slicer.

Filament Workbench ·

Original illustration used to explain the planning context

Start with the actual sliced footprint

Suppose a planning example uses a 220 × 220 mm bed and a rectangular footprint of 60 × 40 mm per part. The footprint must already include the brim or support that belongs to the part. The example retains 10 mm at every bed edge and 5 mm between neighbouring footprints. These dimensions are invented inputs, not a printer specification or a measured manufacturing result.

The usable rectangle is 200 × 200 mm after removing edge clearance twice. Along the width, three 60 mm parts with two 5 mm spaces occupy 190 mm. Along the depth, four 40 mm parts with three spaces occupy 175 mm. The uniform grid therefore holds twelve parts. Rotating every part by 90 degrees gives four columns and three rows, also twelve.

The final plate is a separate run

For a target of 25 good parts, two completely successful twelve-part plates supply only 24. A third run is required for the remaining unit before allowing for any failures. The planner calculates the ceiling of quantity divided by capacity: ceiling(25 ÷ 12) = 3. It does not fill the last plate merely to keep the machine occupied.

This count is not a print-time estimate. A partially filled plate can have different travel, cooling and toolpath behaviour from a full one. Obtain the actual time and filament estimates for each arrangement from your slicer. Record which setup and cleanup tasks happen once for the job and which repeat for every plate.

A rectangle is a useful boundary, not an optimal nest

The tool compares two uniform rectangular grids. It does not mix orientations, fit irregular parts together or account for every machine-specific excluded area. It also does not check printhead collision clearance for sequential object printing. A grid that fits on paper can still be unsuitable for the intended process.

Use the actual slicer arrangement and preview to verify the result. The PrusaSlicer documentation describes automatic arrangement, adjustable gaps and rotation as part of that workflow. Our original enclosure study can help you inspect the modelled shell and lid, but its geometric dimensions are not a replacement for a sliced footprint including supports and brim.

Quote good outcomes and keep the assumptions

A plate count alone does not model failures. If several parts fail together on one plate, independent per-part failure assumptions may understate the risk of another run. Keep the intended good quantity, expected yield and basis for the estimate visible. The calculator treats its inputs as an explicit expectation rather than a promise of finished parts by a particular date.

Export a cost comparison, then record actual good parts, attempted parts, filament, machine time and hands-on time after production. That record can inform a later estimate. The break-even worksheet explores the reserve in a quote separately. None of these tools silently adds tax, shipping or a recommended selling margin.

Plan your own plate →

Sources

Filament Workbench

Your privacy choices

With your permission, we use Google Analytics to understand page visits. Google Analytics stays unloaded without consent. Articles, calculators and 3D views work with either choice.

Optional analytics only

Advertising and personalisation stay off. We send the canonical page address without query strings or fragments, and no calculator entries. Your choice applies only to this site for up to 180 days.

Change your choice here anytime. Withdrawing consent reloads the page to unload Google code; save any open tool inputs first. Privacy and storage details