WORKBENCH / PLATE CAPACITY
Fit the plate.
Plan the batch.
Enter the full sliced footprint, including any brim or support. Compare two uniform grid orientations before you quote the number of runs. These are editable planning dimensions, not printer specifications.
Grid comparison
FROM CAPACITY TO COST
One full plate is not the whole job.
The starting example fits 12 parts on a 220 × 220 mm bed after clearances. A quantity of 25 requires three plates, with the final run partly filled. Record setup time per run and expected print failures in your cost comparison.
Cost the good parts ↗Check in your slicer
This grid does not model mixed rotations, irregular nesting, printhead clearance for sequential printing, adhesion, collision, thermal behaviour or safe printable height. It does not guarantee an optimal layout.
Capacity = floor((usable width + gap) / (part width + gap)) × floor((usable depth + gap) / (part depth + gap)). Edge clearance is removed twice.
Method and reference
Original rectangular packing calculation. Use PrusaSlicer’s arrange guidance to compare this planning grid with an actual sliced arrangement. Geometry volume is not filament consumption: use your slicer’s extrusion estimate.
Inspect the enclosure study ↗